CA-42 USB TO UART DRIVER FOR MAC DOWNLOAD

After opening my usb serial cable I got off ebay I realized that it might not be the same pinout that you have. What can I do to make it function? Check the corresponding cable for your model at Nokia sites The advantages to a pin-row set up is that there are only as many holes as are needed to establish connection and the connector size is significantly smaller than would be a standard DB-9 connector. Open Control Panel 2. Fire up a terminal emulator, and connect it to the correct port e. This completes instrument installation.

Uploader: Tarisar
Date Added: 28 January 2009
File Size: 67.57 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 96883
Price: Free* [*Free Regsitration Required]

Remember that it is.

Start off with wrapping the ground wire to the lower right hand pin on the connection block. Closeup of Dockstar prior to reassembly. As far as the firmware update, not sure.

nokia ca 42 usb uart driver

The PC may recognize the phone as a modem in which you may have to delete the previous installed driver. USB communication therefore provides no specific advantages over a native serial port ca-42 usb to uart the difference in physical connectivity. As far as I can see, my wirings are correct.

Authenticode code signing certificate, bypassing WHQL entirely but of course. Be careful, do your research, check twice, solder once. Your finished holes should look something like below. It is also very clumsy with the driver.

Is there anything I can do to fix this? I did notice that when my CA42 cable was not connected to the Dockstar, minicom would start spouting random gibberish ca-42 usb to uart you said. If you have any questions or corrections, please. The guys over at Plugapps. I have identified mine as be sure to add label on each wire: As a ca-42 usb to uart I va-42 go into this unless I get […]. We apologize for any inconvenience and strongly recommend the use of driver version 4.

Well, it depends on your Nokia I had to fix the inf file because my cable had vendor-customized hardware ID, which does not match Silabs anymore.

nokia ca 42 usb uart driver – oroxyloroke

Caro amigos, Tenho um celular Nokia e um cabo usb CA e. Could I use this method to fix it? We do not intend version 4. But this is where I get stuck again.

FAQ1: Nokia Data / Connectivity Cables DKU-2 DKU-5 CA CA

The reason why a serial port on the Ca-42 usb to uart is a good idea is so that you can get access to the bootloader and flash or TFTP in your own images for use. However, you can check with Nokia for the current versions as well.

Remove the inserted ca-42 usb to uart from the hard disk and tighten up all its screws: If you are using my wiring plan, the GND wire is the single pin by itself on the three pin header we made earlier. What do you think? Bueno muchachos pido perdon si rompi alguna norma del ca-42 usb to uart soy muy.

Hi, How did you add battery? So to use your phone as a modem, you will always have to plug it into the same usb slot you installed your phone on. Eric Cooper July 30th, on 8: These all work fine with my Va-42 N90 and phones on the true nokia CA cable.

William Swanson January 2nd, on 1: